The MGF Register Forums

Might have been a manifold for a ZR160? The ZR160 manifold wouldn't fit the F/TF as it's a different design and is essentially a re-work of the standard manifold which has short primaries. The ZR could do with a manifold which has longer primaries like the F/TF/Elise one. ZR manifold http://www.ptp...

Just finished converting my rear lights and indicators to led ones http://forums.mg-rover.org/picture.php?albumid=720&pictureid=9826 http://forums.mg-rover.org/picture.php?albumid=720&pictureid=9825 Got them from 'warden_jp2008' on Ebay. Not the cheapest you can buy, but none have failed on me yet!!

Ever since I had the suspension tweeked by Techspeed I have used 28psi all round as they recommended and the car handles superbly. I found that 36 at the rear was too hard and also dropping the pressure decreased understeer a bit.

I have seen it reported on another forum before, obviously the change of cat/rear box has moved the flexy nearer the crossmember. Hope you have sorted it!

Well if I am to understand what you mean by hardness as they run too cool then you are incorrect, IK20 have the same heat range as a normal or platinum plug!

I use Denso Iridium IK20 in both my cars with no problems whatsoever!!

Col (TF or ZT260)
NigelH (TF)
Jay n hopefully bel (TF)
Stu & Bev (TF or ZT)
AndyG (ZTT400)
Andrew (Ajay) (ZT260)
Nigel & Jo (F or TF)
Max (ZT260)
StuC (ZT260)
Manxmann (ZT260)
Ragman (ZT260)
Phil Evans (ZT260)
Neil & Julie (TF)
Geoff11 (ZT400)
BPR160 (Trophy F)

David Clelland wrote:

bpr160 wrote:What tyre pressures are you using Dave as I don't get any understeer with that combination.

1.9 bar on the front and 2.0bar on the rear (I think that's about 26psi and 28psi)

Try 28psi all round.

What tyre pressures are you using Dave as I don't get any understeer with that combination.

Depending on date I would be interested in this.

The measurement is ground clearance at the lowest point on the car not the ground clearance for the front spoiler. The lowest point is probably the reinforcement under the seats.

Have you just changed the rear tyres?

A 10w/40 semi synthetic will be fine with no oil additives.

Will do and thanks for that!

David - Do you have the part number for the AP pads?

I've done nearly 10k on my rear set of GY Eagle D3s and they are probably only half worn so something is amiss somewhere.

First of all you will need a MGF Momo hub which you can get from the MGOC or Ebay. The Momo hub kit contains a resistor to fool the SRS system that the airbag is still connected. You will then need the Q/R adapter which bolts to the hub (again check Ebay). The only downside with the Q/R adapter is t...